Mission Control // Web Flasher

Flash MeshCadet

Install MeshCadet firmware on a LilyGo T-Deck Plus straight from your browser, over a USB cable — no toolchain, no command line.

1. Connect your T-Deck Plus

Plug the T-Deck Plus into this computer with a USB-C cable. Use a desktop build of Google Chrome or Microsoft Edge — this page needs Web Serial, which Firefox, Safari, and mobile browsers don't support.

2. Choose a version

Firmware version

3. Choose how to flash

Fresh install writes the whole firmware image (bootloader, partition table, and app) and erases everything on the device. Upgrade writes only the new app firmware in place and leaves your device's identity, config, and conversation history untouched — but only when your device is already running a build with a compatible partition layout (see ADR-0009).

Fresh install Erases and reinstalls the whole chip. Any settings, contacts, or history stored on the device are cleared, the same as a brand-new build. Upgrade Writes only the app firmware. Your device identity, config, and conversation history are preserved — if the device is already running a compatible build.

4. Install

Flashing erases and reinstalls the whole firmware image (bootloader, partition table, and app) — any settings or contacts stored on the device are cleared, the same as a fresh build.

Your browser doesn't support installing firmware over USB, or this page isn't loaded over HTTPS. Use a desktop build of Chrome or Edge, loaded over HTTPS (or from localhost).

Flash status

Shown once you start a Fresh install or Upgrade above. Leave this page open and your device connected until it reads "Done".

Console (detailed log)

No flash operation has run yet.

Prefer to flash manually, or want an older/newer version than what's listed? Grab the merged image (manifest.json) or the app-only update image (manifest-update.json + update-meta.json) straight from the GitHub Releases page instead.